EnOcean

From Domoticz
Jump to: navigation, search

EnOcean

Prerequisites

At the moment the EnOcean Serial Protocol Version 2 (ESP2) and version 3 (ESP3) are supported.
But we recommend to use the ESP3 version of EnOcean (USB stick called USB300 or simular) For ESP2 you need a TCM-120 USB stick or similar.

Device Inclusion

All Sensor devices have a teach-in mode to let the host software (Domoticz) know of it's existence/type.
Before domoticz is accepting any sensors, you will have to perform this action at least once.

Actors On/Off/Dimmers

On/Off Actors

On/Off actors (like normal switches) can be included in the system by going to the 'Light/Switches' tab,
and pressing the 'Manual/Light' switch button.
For these devices you have to choose an ID (1-127) and the Rocker_ID (Switch A/B).
Make sure the SwitchType is set to: On/Off
Set the Actor into 'Learn' mode, and press the test button.

Dimmer Actors

Dimmer actions can be included in the system by going to the 'Light/Switches' tab,
and pressing the 'Manual/Light' switch button.
For these devices you have to choose an ID (1-127) and set the SwitchType to: Dimmer
Set the Actor into 'Learn' mode, and press the test button.

Slave Devices

As you probably also use real hardware to control the On/Off/Dimmers, you will notice that these devices are also in the domoticz system.
You need to make these devices 'Slave' devices for the Domoticz Lights/Switches (See Manual)
This way when you turn On/Off a light, the status is also updated for the Domoticz Lights/Switches.


Please note that probably not all hardware is supported (there are lot's of types with their own special rules)
If this is the case, please let us know, and we try to include them.