Zwave or klikaanklikuit sensor to read existing PIR

Topics (not sure which fora)
when not sure where to post, post here and mods will move it to right forum.
Post Reply
Hein73
Posts: 8
Joined: Sunday 09 September 2018 11:22
Target OS: Raspberry Pi
Domoticz version:
Contact:

Zwave or klikaanklikuit sensor to read existing PIR

Post by Hein73 » Saturday 15 September 2018 14:15

HI,

Question: is it possible to use a zwave or klikaanklikuit device to read the status of an existing PIR? the devices I find either switch or are magnetic door contacts.

thnx!

kind regards,

Hein

Ron
Posts: 129
Joined: Saturday 28 December 2013 0:29
Target OS: Raspberry Pi
Domoticz version: 2.2284
Location: Nederland
Contact:

Re: Zwave or klikaanklikuit sensor to read existing PIR

Post by Ron » Saturday 15 September 2018 16:20

I think you can use the Fibaro binairy sensor for that.
I use them to build in a PIR sensor to transfer the status via Zwave to Domoticz.

Post Reply

Who is online

Users browsing this forum: spider2 and 3 guests