Best way of achieving on command on meter readings?

Post Reply
stuiow
Posts: 201
Joined: Saturday 18 April 2015 18:56
Target OS: Raspberry Pi
Domoticz version: 3.6857
Location: Isle of Wight, United Kingdom.
Contact:

Best way of achieving on command on meter readings?

Post by stuiow » Monday 13 August 2018 10:44

I have a power meter that monitors electricity of the house.
I now have solar generation too.
I want to add the ability for some devices to be turned on when my electricity hits something like -2000 Watts.
Can I achieve this with blocky?
I tried a simple blocky but the off command were being sent far too frequently.
Thanks
Stuart

Sent from my SM-G955F using Tapatalk

Now setup on a RPI3.
Also using Evohome HGI80, RFXTRX433E and a Aeotec Gen5 stick. Mainly a Gen5 Z-Wave system.
My weather (Davis vantage Pro2) data is obtained by weatherunderground
Now collecting rtl_433 data from Apollo Ultrasonic meter

freijn
Posts: 378
Joined: Friday 23 December 2016 17:40
Target OS: Raspberry Pi
Domoticz version:
Location: Netherlands Purmerend
Contact:

Re: Best way of achieving on command on meter readings?

Post by freijn » Monday 13 August 2018 12:54

Hi,

There is a bathroom extract fan script in Lua. That one has a monitor in time steps.

I believe that would a good start to first check the status over a few minutes and then do the switching.
( no blocky sorry )

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests