Error opening url:

Topics (not sure which fora)
when not sure where to post, post here and mods will move it to right forum.
Post Reply
Posts: 220
Joined: Tuesday 24 June 2014 19:02
Target OS: Raspberry Pi
Domoticz version:
Location: struggling and stumbling. Amsterdam area

Error opening url:

Post by BertB » Wednesday 01 August 2018 16:32

I have read a lot about this issue, but have not yet found an answer.
Domoticz V4.9796

I use a Domoticz switch to configure a display in an ESPEasy device.
When the switch is on, it sends in the On action :

Code: Select all,page0.vFont.val=1
In the Off action

Code: Select all,page0.vFont.val=0
When I entere these commands in a web browser, I get no error message.
When I push the switch, I get:

Code: Select all

2018-08-01 16:29:44.203 Status: User: Admin initiated a switch command (293/RFLVijferpomp/Off)
[u]2018-08-01 16:29:44.933 Error: Error opening url:,page0.vFont.val=0 [/u]
Strangely enough, the correct action is done in the ESPEasy device.

I use this method quite some time now, but I cannot remember this error before.

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests