Neo Coolcam Door Sensor loose status

Post Reply
stutmich
Posts: 4
Joined: Monday 30 October 2017 22:23
Target OS: NAS (Synology & others)
Domoticz version:
Contact:

Neo Coolcam Door Sensor loose status

Post by stutmich » Friday 13 July 2018 18:18

Hi

I have a couple of door sensors at home. The are working fine so far. But one sometimes I lost the status from the sensor in Domoticz.

Scenario:
1. Window open --> Sensor Status = on --> LOG entry in device log in domoticz --> OK
2. After a couple of minutes (ca. 20-30) --> Window did not change position --> Domoticz shows --> Off (window closed), but there is no entry in the device log neigther in the general log file about an event from the window sensor.
It seams that domoticz "decides" to show off.

I do not know why.

any ideas.

Thx
Michael

stutmich
Posts: 4
Joined: Monday 30 October 2017 22:23
Target OS: NAS (Synology & others)
Domoticz version:
Contact:

Re: Neo Coolcam Door Sensor loose status

Post by stutmich » Tuesday 17 July 2018 20:29

no ideas?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest