Door Sensor sends ON/ON instead of ON/OFF

433Mhz opensource Receiver & Transmitter.

Moderator: Stuntteam

Post Reply
jannnfe
Posts: 32
Joined: Tuesday 30 January 2018 1:27
Target OS: Linux
Domoticz version: Beta
Location: Germany
Contact:

Door Sensor sends ON/ON instead of ON/OFF

Post by jannnfe » Friday 13 July 2018 11:07

Hello,
I had asked for a solution in the LetsControlIt Forum, but unfortunately I was not helped there until then. I hope someone can help me here. I'll post the link to my forum post here and hope someone can help me https://www.letscontrolit.com/forum/vie ... 111#p29111.

The point is that my RFLink from a door sensor receives an ON command from the sensor for both opening and closing. I would like to change this so that I always know when the door is open and closed.

At the Moment:
OPEND = ON
CLOSED = ON

I like to receive:
OPEN = ON
CLOSED = OFF

Thanks :)

freijn
Posts: 402
Joined: Friday 23 December 2016 17:40
Target OS: Raspberry Pi
Domoticz version:
Location: Netherlands Purmerend
Contact:

Re: Door Sensor sends ON/ON instead of ON/OFF

Post by freijn » Friday 13 July 2018 11:18

Create a small script with an virtual switch.

Toggle the status Open / Close by every on command.
I think you can even do that in blocky

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests