Netatmo wind gauge - how fast are wind peaks reported to domoticz

Others (MiLight, Hue, Toon etc...)
Post Reply
booster
Posts: 34
Joined: Wednesday 10 December 2014 21:33
Target OS: Raspberry Pi
Domoticz version:
Location: Rijssen, The Netherlands
Contact:

Netatmo wind gauge - how fast are wind peaks reported to domoticz

Post by booster » Thursday 23 November 2017 17:55

I'm thinking about adding a netatmo weather station to my setup.
A main reason is to also have the wind gauge to measure windpeaks / gust.
I wanted to use it for taking my sunscreen back in when it gets too windy, to avoid damage..

However, I'm wondering how fast windpeaks are reported back to domoticz? As domotics pulls the data from netatmo - is this still going in 10 minutes intervals? In that case it might be too much delay for my purpose ;)

Can anyone advice if this will be suitable, or should I better go for a device on 433mhz and direct communication?
Connected to:
-Pi3; Aeon Labs Z-Stick; Fibaro Switches, Roller Shutter and Motion Sensors; Qubino Dimmers; P1 Port + Youless, MiLight; HUE Bridge; Forest shuttle Z-Wave; RFLink + KAKU; Voltcraft CO20; Everspring floodsensors; GreenWave PN-6; NEO Sensors

pipari
Posts: 66
Joined: Saturday 23 November 2013 22:51
Target OS: Raspberry Pi
Domoticz version:
Contact:

Re: Netatmo wind gauge - how fast are wind peaks reported to domoticz

Post by pipari » Sunday 17 December 2017 22:56

If they make the poll-value a configuration you can use it :) Or you can change it yourr self and compile :)

Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests