Configuring a Sonoff 4 channel on Domoticz/mqtt help needed

On various Hardware and OS systems: pi / windows / routers / nas, etc
Post Reply
femuruy
Posts: 9
Joined: Sunday 23 July 2017 3:05
Target OS: Raspberry Pi
Domoticz version:
Contact:

Configuring a Sonoff 4 channel on Domoticz/mqtt help needed

Post by femuruy » Thursday 26 October 2017 13:24

Hello guys i need some help on how to configure a Sonoff 4ch (4 channel relay) with ESPeasy last version already installed on with raspberry pi3/Domoticz/MQTT because i am utterly confused!
how do i add it to domoticz and how do i add each of the individual channels so i can operate them independently?

Thank you in advance for your help!

FemurUY

femuruy
Posts: 9
Joined: Sunday 23 July 2017 3:05
Target OS: Raspberry Pi
Domoticz version:
Contact:

Re: Configuring a Sonoff 4 channel on Domoticz/mqtt help needed

Post by femuruy » Tuesday 31 October 2017 12:05

any takers?
Image

femuruy
Posts: 9
Joined: Sunday 23 July 2017 3:05
Target OS: Raspberry Pi
Domoticz version:
Contact:

Re: Configuring a Sonoff 4 channel on Domoticz/mqtt help needed

Post by femuruy » Tuesday 14 November 2017 0:36

Help still needed lads :)

RadioAir
Posts: 2
Joined: Tuesday 14 November 2017 21:06
Target OS: Raspberry Pi
Domoticz version:
Contact:

Re: Configuring a Sonoff 4 channel on Domoticz/mqtt help needed

Post by RadioAir » Tuesday 14 November 2017 21:16

In Tasmota you can configure each channel seperately by Idx number. Is it possible to enter that in ESPEasy as well? That should be your answer.
The Idx number is found after adding your MQTT Gateway hardware device and a Dummy switch. You can select Add virtual switches after that to create 4 switches, which you can use with your 4ch Sonoff.

On Tasmota this all works fine, however I do not have any experience with ESPEasy. Good luck!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest