How to manually add 433MHz Lighting4 switch with Pulse = 230usec

Post Reply
timsteeman
Posts: 3
Joined: Monday 01 May 2017 20:53
Target OS: Raspberry Pi
Domoticz version: 3.5877
Location: Noord Brabant
Contact:

How to manually add 433MHz Lighting4 switch with Pulse = 230usec

Post by timsteeman » Tuesday 02 May 2017 8:22

Hello all,

I have an old set of Ranex RX 2582 switches (433,92MHz) and a remote.

Already discovered the below codes and Pulse timing. (230usec)
Via the "learn" mode the remote commands are not recognized.

I need to manually add these switches according to the below codes and a Pulse timing of 230usec.

How can I add a switch according to the specific settings?

(i found the Itho CVE RFT (also Lighting4) but that uses a diffreent pulse timing I'm afraid, tested and it won't work, different Pulse Timing?)
Manually adding these codes into RFXmngr works perfectly, but how to integrade them into Domoticz?

Example:
1 OFF = 3F 00 00 - (RFXcom 0011 1111 0000 0000 )
1 ON = 3F 00 C0 - (RFXcom 0011 1111 1100 0000 )

GCB2016
Posts: 32
Joined: Thursday 10 November 2016 23:13
Target OS: Raspberry Pi
Domoticz version: V3.9208
Location: Rotterdam
Contact:

Re: How to manually add 433MHz Lighting4 switch with Pulse = 230usec

Post by GCB2016 » Friday 29 December 2017 20:22

Hi Tim, did you ever find the answer to your question? I would appreciate a reply :) Thanks!

Nunox
Posts: 1
Joined: Sunday 08 April 2018 0:03
Target OS: -
Domoticz version:
Contact:

Re: How to manually add 433MHz Lighting4 switch with Pulse = 230usec

Post by Nunox » Sunday 08 April 2018 0:09

Hi Tim,
Same issue here. Any advice?
Thanks

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests