Visualize usuported Mysensors value into Domoticz

Post Reply
bilbolodz
Posts: 12
Joined: Wednesday 15 March 2017 10:43
Target OS: Raspberry Pi
Domoticz version:
Contact:

Visualize usuported Mysensors value into Domoticz

Post by bilbolodz » Tuesday 30 May 2017 17:52

My sprinkling controller (own build Mysensors node) reports progress of watering sending V_PERCENTAGE message. Domoticz doesn't support S_SPRINKLER sensor types I've tried to set "watering switch" as Dimmer and reports progress to Domoticz but there are a lot od disadvantages....
Is it possible to create dummy "Percenage" devices (it's possible) and feed it with data send over Mysesnors network from my sprinkler controller? I'm using RPI GPIO Mysensors.

alexsh1
Posts: 274
Joined: Wednesday 30 September 2015 11:50
Target OS: Raspberry Pi
Domoticz version: v3.8975
Location: United Kingdom
Contact:

Re: Visualize usuported Mysensors value into Domoticz

Post by alexsh1 » Thursday 01 June 2017 22:14

Is it possible to create dummy "Percenage" devices (it's possible) and feed it with data send over Mysesnors network from my sprinkler controller? I'm using RPI GPIO Mysensors.
I do not think it is possible. If you were to use esp8266 and wifi then updating JSON would update your virtual switch, but this is not the case.

RidingTheFlow
Posts: 78
Joined: Friday 11 March 2016 19:23
Target OS: Raspberry Pi
Domoticz version:
Location: Essex, UK
Contact:

Re: Visualize usuported Mysensors value into Domoticz

Post by RidingTheFlow » Monday 05 June 2017 21:22

You can use either temperature/humidity or voltage. Voltage has advantage that its pretty high precision.
Temperature/humidity allows to graph combine two independent values on one chart. Humidity good for "percentage" values (0-100%).

Boots33
Posts: 12
Joined: Sunday 13 December 2015 7:41
Target OS: NAS (Synology & others)
Domoticz version:
Contact:

Re: Visualize usuported Mysensors value into Domoticz

Post by Boots33 » Tuesday 20 June 2017 5:21

I have used S_DUST/V_LEVEL to display percentage. Have a look at https://forum.mysensors.org/topic/5157/ ... ant-volume

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests