GPIO UART on Nanopi NEO

Post Reply
MarcoOmniabit
Posts: 1
Joined: Tuesday 12 June 2018 14:11
Target OS: Raspberry Pi
Domoticz version:
Contact:

GPIO UART on Nanopi NEO

Post by MarcoOmniabit » Monday 18 June 2018 17:59

Hello,

I installed Domoticz on both Raspberry and Nanopi NEO. I tried to inform myself about the use of the various interfaces made available by these devices and I managed to drive a simple LED connected to a generic GPIO pin by selecting the appropriate item from the "type" menu into Setup -> Hardware. Instead when I choose one of the hardware supported by domoticz, on the raspberry I have the ability to choose as a port both the USB and the ttyS0 (and AMA0). The latter should be the UART on the GPIO. While on the Nanopi NEO I can only choose the USB ports and I can not understand why.

Regards
Marco

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest