I have this light sensor: http://www.uugear.com/product/uugear-li ... og-output/
It seems to work well and I can read it's status from Raspi3 GPIO pin. The status is either 1 or 0 (light/dark). I have a problem connecting this to Domoticz. I am able to add the hardware and "switch" but I can't figure out how to get readings out so that the "switch" changes it' state to on or off. What am I missing here, do I need scripting?
Any help is greatly appreciated!
2 posts • Page 1 of 1
- Posts: 30
- Joined: Sunday 11 December 2016 19:30
- Target OS: Raspberry Pi
- Domoticz version:
Users browsing this forum: No registered users and 1 guest