I run domoticz on a Udoo Quad.
I want to use the GPIO's of that but all the manuals are written for raspberry.
Anyone an idea if it is possible to use 1 wire device for that in Domoticz?
I use pin 7 for a relay, it has the path /sys/class/gpio/gpio42/
But if I add a 1-wire device in hardware with the path /sys/class/gpio/gpio42/ it does not show up in devices.
I can use the pin from commandline with these commands: “echo 0 > /gpio/pin25/value” “echo 1 > /gpio/pin25/value”
Anyone an idea?
1 post • Page 1 of 1
Users browsing this forum: No registered users and 2 guests