Nexa Motion sensor

Topics (not sure which fora)
when not sure where to post, post here and mods will move it to right forum.
Post Reply
Posts: 10
Joined: Wednesday 27 December 2017 16:28
Target OS: Raspberry Pi
Domoticz version:

Nexa Motion sensor

Post by steffo » Wednesday 07 November 2018 0:48

Hello all,
I have a Domoticz Version: 4.9700 on a Rpi.
It is connected to a RFXtrx433 USB 433.92MHz .

I am trying to add the Nexa device LMDT-810 motion sensor but I can not get Domoticz to find it.
It was working today in another Synology based installation but I moved the RFXtrx to Raspberry as this is where I will be in the future.

Can anyone suggest how to add this device?
Thanks for help and supprt!

Posts: 5
Joined: Wednesday 07 November 2018 21:06
Target OS: Raspberry Pi
Domoticz version: 4.97
Location: Jessheim, Norway

Re: Nexa Motion sensor

Post by gamlebardun » Sunday 11 November 2018 6:42

I just added one, the outdoor type. I read the manual, and flipped the switch. The unit can easily be dismounted, so I brought it close to my pi+433trx. I left it alone for a minute, then waved my hand over it, and domoticz registered a signal.
I did try a few times before success. Make sure lighting sensitivity is "always on" when adding it. You can set another value after.

Post Reply

Who is online

Users browsing this forum: elmortero and 8 guests