Page 1 of 1

Execute OS command after 30 sec???

Posted: Wednesday 06 December 2017 19:23
by DutchHans
Good evening..
I am facing a little problem.. I have 5 wlan speakers(with built-in amplifiers). They fall asleep when they had no signal for 15 minutes.

I can wake them simply by switching powercord off and on with a 433mhz switch.. than it will connect to wlan (this takes about 30 seconds)

Here's the problem.. in blockly i can wake them and send a url from logitech media server to hear the radio.. but I want to send this url when the Wlan-Speaker has completely booted..

Ive tried blockly (not possible) but prefer LUA..(here I need to execute a curl/http command after 30 seconds. So first bootup the Wlan-Speaker and 30 sec later execute the url..

Is this possible?

Regards,Hans

Re: Execute OS command after 30 sec???

Posted: Wednesday 06 December 2017 22:25
by markjgabb
viewtopic.php?f=59&t=20510

Check this thread out. Couple of guys here solved this for me a while ago

Re: Execute OS command after 30 sec???

Posted: Thursday 07 December 2017 16:02
by DutchHans
Perfect, thank you very much.

Cheers, Hans