I have problem slave switch mode for output.
If I manually click output picture, relay go on and off.
If I try control same output by slave, only picture change but relay not change state.
Can someone help?
2017-02-11 14:43:38.808 User: Admin initiated a switch command (9/PF_RELE 1/On)
2017-02-11 14:43:38.808 (PiFace) Lighting 1 (PF_RELE 1)
2017-02-11 14:44:26.425 (PiFace) Lighting 1 (PF_IN_1)
2017-02-11 14:44:31.405 Error: Piface: wrong housecode I
2017-02-11 14:44:37.185 Hardware Monitor: Fetching data (System sensors)
2017-02-11 14:44:38.934 (PiFace) Lighting 1 (PF_IN_1)
1 post • Page 1 of 1
Users browsing this forum: No registered users and 1 guest