Page 1 of 1

PiFace2 custom switch discription

Posted: Sunday 23 October 2016 12:58
by happyman

To check if the frontdoor is open or closed I use a normal doorcontact connected to a PiFace.
In the PiFace configurationfile the connected pin is configurated as level. This works fine.

In the Domoticz interface the switch is shown as an lightning icon with an bulb-picture and shows 'On' and 'Off' .
That is not what I want. I want it to be shown as an doorcontact with 'Open' and 'Close'.
I can change the icon to a door, but the text does not change.
Is there a way to change this?