device dies for the second time

For Z-Wave related questions in Domoticz
Post Reply
rob0t1704
Posts: 7
Joined: Wednesday 03 January 2018 13:41
Target OS: Raspberry Pi
Domoticz version:
Contact:

device dies for the second time

Post by rob0t1704 » Monday 17 September 2018 16:34

A Qubino ZMNHND1 Flush 1D relay+ module dies after a couple of weeks. It shows the red dot with the exclamation mark in the hardware tab. I have had the same problem a month ago and replaced the node.
I found it hard to believe that two equal devices in the same location (physically) stops working. They are not damaged and there's no reason why they stopped working. If I look at the zwave illustration I can see the node but no connection to an other node. I have attached a jpg file with the illustration. Is there a logical explanation?
It is node 26.
Attachments
zwave-nodes.jpg
picture of the zwave network
zwave-nodes.jpg (101.7 KiB) Viewed 126 times

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests