Z-Uno multiple Sensors not seen in Domoticz

For Z-Wave related questions in Domoticz
Post Reply
Wolfgang
Posts: 7
Joined: Saturday 28 October 2017 21:37
Target OS: Raspberry Pi
Domoticz version:
Contact:

Z-Uno multiple Sensors not seen in Domoticz

Post by Wolfgang » Saturday 04 August 2018 17:14

Hello there ,
I'm searching for the solution of following problem in domoticz :
I am using a z-uno device with multiple channels setup :

1 Binary-Switch ZUNO_SWITCH_BINARY
1 Multilevel-Sensor Distance
1 Multilevel Sensor Tankcapacity
1 Multilevel Sensor General Purpose with Percent Scale

When I connect the device to domoticz the openzwave panel shows the devices as seen below
The attachment openzwave.png is no longer available
but in domotics only 1 multilevel sensor is seen beside the binary switches :
openzwave.png
openzwave.png (42.53 KiB) Viewed 178 times
Any suggestions how to fix this problem ?

Regards Wolfgang

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests