Fibaro RGBW controller - RGB strip + analog temperature sensor

For Z-Wave related questions in Domoticz
Post Reply
morscerta
Posts: 1
Joined: Wednesday 15 March 2017 0:23
Target OS: Raspberry Pi
Domoticz version:
Contact:

Fibaro RGBW controller - RGB strip + analog temperature sensor

Post by morscerta » Wednesday 15 March 2017 0:25

Hi.
I have a Fibaro RGBW module that I connected to a RGB strip (note that there is no +W). I use a Raspberry Pi + Domoticz + Aeon Z-Wave Stick as a controller. Everything worked fine. Then I connected an analog temperature sensor LM35DZ that outputs 0-10V, so theoretically should work well with RGBW module. I attach a scheme of how I connected the modules.
Fibaro RGB Temp.png
Fibaro RGB Temp.png (9.81 KiB) Viewed 671 times

RGB color-changing functionality still works, however I seemingly can't figure out how to read a temperature/voltage from the sensor. I understand that the trick is in properly defining a parameter 14. I tried a number of different versions of parameter 14 that I found on the Internet or deduced myself. I can't get anything to work, including 39320 which I think should be the correct one (1001-1001-1001-1000, all normal monostable out, in4 analog in).

I don't need any switches, I want to operate RGB through a Domoticz only. Is it possible to operate an RGB strip at the same time with analog 0-10V sensor? How should I connect and configure the node? What parameter 14 should be like?

Thanks in advance,
m.

TheDane
Posts: 3
Joined: Sunday 03 December 2017 8:44
Target OS: NAS (Synology & others)
Domoticz version: v3.8153
Location: Denmark
Contact:

Re: Fibaro RGBW controller - RGB strip + analog temperature sensor

Post by TheDane » Tuesday 13 February 2018 6:07

Hi.
Did you find a solution regarding the temp sensor?
Does it work ok with the rgwb module, maybe without the strip?
I'm asking because I would like to use the module with a pressure sensor and the lm35dz, but are unsure about the compatibility.
Tia
Regards
Kurt - TheDane

User avatar
emme
Posts: 798
Joined: Monday 27 June 2016 11:02
Target OS: Raspberry Pi
Domoticz version: latest
Location: Milano, Italy
Contact:

Re: Fibaro RGBW controller - RGB strip + analog temperature sensor

Post by emme » Tuesday 13 February 2018 9:54

following the fibaro logic... it could be that once you connect the temp sensor you have to exclude and re-include the device in the zWave Network

(for door sensors it works like that :( )
That's one small step for a programmer, one giant leap for me!
- - - - -
Raspberry Pi3 + AeonStick G5 + RFXCOMM433 + iRTrans Server + NodeJS
There's no stress in the mess!!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest