Get info from homealarm (chuango)

For Z-Wave related questions in Domoticz
Post Reply
Ivanhoe1
Posts: 8
Joined: Monday 19 December 2016 21:42
Target OS: Windows
Domoticz version:
Contact:

Get info from homealarm (chuango)

Post by Ivanhoe1 » Tuesday 10 January 2017 14:06

Hi,
Checking possiblities to connecta a sensor (like Fibaro Universalsensor) to my home alarm (chuango g5).
I would like to get inputs to domoticz when the alarm is activated/dectivated and when the alarm goes off. Do you think its possible to connect any universalsensor to the outputs (see attached image) to get this info?
Attachments
Skärmklipp.JPG
Skärmklipp.JPG (21.76 KiB) Viewed 386 times

User avatar
jadon
Posts: 9
Joined: Monday 07 November 2016 15:59
Target OS: Raspberry Pi
Domoticz version: Beta
Location: Tiel, Netherlands
Contact:

Re: Get info from homealarm (chuango)

Post by jadon » Friday 13 January 2017 16:16

Chuango uses 433 protocol. I have the same (only branded as Eminent) and I would also like to know how to turn the alarm on/off. But I guess it wouldn't make it very secure if you can switch it off wireless... :)

Maybe you can use the electronic lock relay for detecting if the alarm is activated/deactivated), but you should check the manual for specs

User avatar
emme
Posts: 481
Joined: Monday 27 June 2016 11:02
Target OS: Raspberry Pi
Domoticz version: latest
Location: Milano, Italy
Contact:

Re: Get info from homealarm (chuango)

Post by emme » Friday 13 January 2017 16:22

you can intercept the radio communication of each device (433mhz) but you have to note that chiango does NOT send the close signal, just the OPEN (for reed devices)

I had one, and I'm actually migrating to Zwave (well.. the chuango controller exploded due to battery leack :P :P)
That's one small step for a programmer, one giant leap for me!
- - - - -
Raspberry Pi3 + AeonStick G5 + RFXCOMM433 + iRTrans Server + NodeJS
There's no stress in the mess!!

Ivanhoe1
Posts: 8
Joined: Monday 19 December 2016 21:42
Target OS: Windows
Domoticz version:
Contact:

Re: Get info from homealarm (chuango)

Post by Ivanhoe1 » Sunday 15 January 2017 22:51

jadon wrote:Chuango uses 433 protocol. I have the same (only branded as Eminent) and I would also like to know how to turn the alarm on/off. But I guess it wouldn't make it very secure if you can switch it off wireless... :)

Maybe you can use the electronic lock relay for detecting if the alarm is activated/deactivated), but you should check the manual for specs
Yes and the output for wired siren might work as input to domoticz for triggerd alarm.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests