L&S Systems LEDS - How to determine protocol?

Others (MiLight, Hue, Toon etc...)
Post Reply
Posts: 1
Joined: Sunday 18 March 2018 15:47
Target OS: NAS (Synology & others)
Domoticz version:

L&S Systems LEDS - How to determine protocol?

Post by antonvh » Sunday 18 March 2018 16:56


I have these L&S 'Emotion' leds in my kitchen. They can be remote controlled with some radio signal. I opened up one of the remotes, but I cannot figure out what protocol or frequency it is. Their website is not very helpful either. Could you point me in the right direction?

- Should I investigate, reverse engineer?
- Is it a familiar system?
- Should I just replace the whole rf system by a different one that is easier to link to domotics? If so, is there a standard system that can dim and change light temperature on LED lights with two wires?
- Should I just forget about this and buy a different lighting system?

Here is the receiver:
IMG_4709.JPG (397.26 KiB) Viewed 341 times
Remote inside
IMG_4706.JPG (280.11 KiB) Viewed 340 times

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests