NodOn MSP-3-1-XX Micro Smart Plug

Post Reply
guantolento
Posts: 161
Joined: Saturday 01 October 2016 14:48
Target OS: Raspberry Pi
Domoticz version: LastBeta
Location: Italy BG
Contact:

NodOn MSP-3-1-XX Micro Smart Plug

Post by guantolento » Thursday 29 December 2016 20:48

hi, someone use this device in domoticz? i don't find any kind of topic in the forum about this. this evening i connect this device to domoticz without problem. i need to say wich setting i need to give in the hardware device because i find a lot of parameters.
Master (pi3) - MB sensors + Dummy + Sysfs gpio + 1 NodOn MSP-3 + 1 Aeotec DSB28 Energy Meter + 3 Danfoss RS Room + 7 Danfoss Z Thermostat + 1 Swiid Inter + 9 FGS222
Slave01 (pi2) - MB sensors + Dummy + Weather Underground + 2 FGS223 + 1 FGWPE/F

guantolento
Posts: 161
Joined: Saturday 01 October 2016 14:48
Target OS: Raspberry Pi
Domoticz version: LastBeta
Location: Italy BG
Contact:

Re: NodOn MSP-3-1-XX Micro Smart Plug

Post by guantolento » Friday 30 December 2016 1:43

Good evening,
after several tests I have to clarify the following parameters:

23.Energy Auto Sending Report
This parameter will send a new energy report automatically if the energy value changes of x Wh (Watt Hour) compared to the last report.(1 to 65535, default 1000)

25.Power High Threshold
This parameter defines the high threshold power value (1 to 65535, default 20)

26.Power Low Threshold
This parameter defines the low threshold power value (1 to 65535, default 5)

what do mean ? thanks to all.
Master (pi3) - MB sensors + Dummy + Sysfs gpio + 1 NodOn MSP-3 + 1 Aeotec DSB28 Energy Meter + 3 Danfoss RS Room + 7 Danfoss Z Thermostat + 1 Swiid Inter + 9 FGS222
Slave01 (pi2) - MB sensors + Dummy + Weather Underground + 2 FGS223 + 1 FGWPE/F

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests