Can't control Neocam plug (but data is read correctly)

Post Reply
caylus
Posts: 1
Joined: Monday 18 June 2018 8:45
Target OS: Raspberry Pi
Domoticz version:
Contact:

Can't control Neocam plug (but data is read correctly)

Post by caylus » Monday 18 June 2018 9:15

Hey,

I'm trying to use RaZberry with Domoticz (Beta version).

I created a symlink (following this guide: https://www.vesternet.com/resources/app ... I7cfnXhDqP).

My Neocam plug is detected:
nodes.png
nodes.png (28.76 KiB) Viewed 387 times
And in the device screen I see a few devices:
devices.png
devices.png (44.44 KiB) Viewed 387 times
But when I try to actually control the plug, it doesn't do anything.
These are the switches I'm trying to use:
Switches.png
Switches.png (11.53 KiB) Viewed 387 times
If I switch on/off the lamp switch, it claims that now the lamp is on / off but nothing happens IRL, and if I try to switch on the power management I get "Error sending switch command, check device/hardware !".

I'm now a bit stumped. If anyone has any ideas, I'd be grateful.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest