Sensor type for binary status?

Post Reply
miljume
Posts: 72
Joined: Thursday 03 December 2015 22:36
Target OS: Raspberry Pi
Domoticz version: v3.8742
Contact:

Sensor type for binary status?

Post by miljume » Monday 30 October 2017 11:32

Hello,

Is there any dummy sensor to be used in Domoticz to only show status on a device?

I would like to monitor a binary sensor and just show a green or red light depending on the status of the sensor (like flooding sensor etc)

Alert sensor is close but for some of my sensors it doesnt make sense, for example to show if a pump is running or not

JeanChristophe
Posts: 20
Joined: Tuesday 18 April 2017 19:21
Target OS: Raspberry Pi
Domoticz version:
Contact:

Re: Sensor type for binary status?

Post by JeanChristophe » Friday 03 November 2017 15:03

Is the ON/OFF switch with the "Generic" icon not OK.
Red/Green status. Pretty clear :-)

miljume
Posts: 72
Joined: Thursday 03 December 2015 22:36
Target OS: Raspberry Pi
Domoticz version: v3.8742
Contact:

Re: Sensor type for binary status?

Post by miljume » Friday 03 November 2017 16:47

That's close but no cigar

Why? Because it is still a switch that can be clicked on

I want just a status light that shouldnt do anything more than just show green if its activated and red orange blank if not

Skickat från min ONEPLUS A5000 via Tapatalk


JeanChristophe
Posts: 20
Joined: Tuesday 18 April 2017 19:21
Target OS: Raspberry Pi
Domoticz version:
Contact:

Re: Sensor type for binary status?

Post by JeanChristophe » Friday 03 November 2017 19:58

You can protect the switch (edit > protected) to avoid an accidental click. :-/

That's the best I can do :)

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests